Kuangxin has been producing and manufacturing supercharged cylinders for 30 years. Now I want to share the attention of the supercharged cylinders:
1. Since the supercharged cylinder is often in a state of high speed operation, it is easy to cause machine wear. Therefore, the operation manual should be followed. The operating temperature of the supercharged cylinder is around -5 °C ~ 60 °C, and the operating speed is 50 ~ 1000 mm/s.
2. Keep Clean
3. Before connecting the pressurized cylinder to the air path, please remove the dust and other debris in the pipeline and components to avoid reducing the service life of the pressurized cylinder.
4. Use within normal pressure range
5. The working pressure of the pressurized cylinder during normal use must work within the working pressure range specified in the inspection report and must not exceed the specified working pressure. And ...
6. Pay attention to the working environment of the booster cylinder
7. The temperature of the pressurized cylinder in the working environment at the time of design has been set. If the work environment needs to change beyond the temperature, contact the relevant personnel of the pressurized cylinder technology.
8. Since some of the components in the cylinder are iron, please do not use them in a particularly complex environment(such as the contact environment of chemical substances). In addition, please install an effective air treatment element(three-point combination) at the front of the 9.
10. Do not tamper with other hydraulic fluids
The hydraulic oil medium used in the design of the booster cylinder is VG68 # anti-wear hydraulic oil, and other liquid media(such as oil, water, etc.) can not be used without permission.
11. Be sure to follow procedure
12. The action program must work in accordance with the action program of the air route assembly diagram, namely pre-pressure action-supercharged action-pre-pressure reduction
13. Pay attention to maintenance, often check the operation of the booster cylinder
14. In order to avoid the pressure of the cylinder during the pressurization action to damage your mold or workpiece, please install a pressurization valve at the entrance of the pressurization section to protect your product effectively.
15. In order to ensure the stability of the work of the booster cylinder, it is recommended to install a gas storage cylinder in parallel between the triplet and the booster cylinder as far as possible.
16. It is recommended to replace all the hydraulic fluids in the cylinder once when more than 500,000 times or more than half a year are used to increase the service life and working life of the cylinder.